Creates a pad to a selected surface. The limiting surface must totally enclose the pad profile for the pad to stop. Similar to the above
options, modifications to the limiting surface reflect in the pad.
See Full-Size Image
See Full-Size Image
Offset
Offsets the end of the pad a set value from the limiting face, plane, or surface. This option is not available for the Dimension
option. The following figure shows the pad offset 5mm from the limiting surface.
See Full-Size Image
See Full-Size Image
Profile/Surface
The Selection text box indicates the sketch used to create the pad. If no sketch geometry exists, click Sketcher in the dialog to
create the geometry on a face or plane. You can also edit existing sketches with this selection. You can pick open profiles as long as the
existing geometry can trim the resulting pad. You can extrude multiple profiles as long as they don't intersect.
See Full-Size Image
See Complex Profiles at the end of this document for information about creating pads from sketches with intersecting geometry.
Thick
Activates the Thin Pad options in the More area of the dialog.
See Full-Size Image
Reverse Side
See Full-Size Image
Defines the direction the pad material will be created in. This option is only available when an open profile is selected.
See Full-Size Image
See Full-Size Image
See Full-Size Image